CNC routing
Free Furniture & Flat-Pack vector files
Stools, stands, shelving and nesting-ready panels.
- 0 files
Furniture files leave the sheet and go straight to the router table. Geometry is drawn at 1:1 in millimetres with inside-corner relief where a 6 mm end mill cannot reach, so parts seat fully without hand chiselling.
Every panel set includes a nesting layout for a 1220 × 2440 mm sheet and a cut list with grain direction marked. Toolpaths are deliberately not baked in: your machine, your feeds, your hold-down strategy.
Load-bearing design advice is given for 18 mm birch plywood. If you substitute MDF, increase panel thickness by 20 % and never use MDF for anything that will be lifted by a single rail.
Nothing matched that combination
Try removing a filter.
Furniture & Flat-Pack — questions we get
2 answers01Do I need dog-bones on the internal corners?
The files include them where a round tool cannot clear the corner. They are drawn on the CUT layer at 3.2 mm radius for a 6 mm tool. Change the radius if you run a 3 mm cutter.
02Can these be cut on a desktop CNC?
The stands and small shelving fit a 600 × 900 mm bed. Full stools need tiling — the panels are split at the joint lines so each half can be cut separately.